General ventilation and extraction, cooling and refrigeration, environmental control, crop storage, petrochemical process ventilation and emergency ventilation up to 400°C/2h.
JM Aerofoil fans short cased for duct or plate installation. Casings are spun from sheet steel with integral pre-drilled and radiused inlet flanges. The galvanised finish gives a high resistance to corrosion and is ideal for external as well as internal use
A unique high efficiency aerofoil section blade with a purposely smoothed hub and clamp plate for adjustable pitch angle availability.
The Fläkt Woods impellers are all high pressure die cast to offer thin aerofoil sections for low generation of noise.
Every cast aluminium component is X-ray examined using Real Time Radiography inspection prior to assembly.
The maximum pitch angles shown allow for speed control by frequency inverter (3ph only).
Squirrel cage asynchronous motors totally enclosed.Insulation class F and protection F
Suitable for horizontal through to vertical shaft operation
Sealed for life bearings lubricated with wide temperature range grease. The motors are fitted with overheat protection thermostat.
Supply:230V 1ph 50Hz or 400V 3ph 50Hz
Standard 3f fans can be offered for a one off emergency operation at 200°C for 2 hours.
ATEX II 2G IIB T4 version
Smoke version 300°C/2h or 400°C/2h
2-speed motors
Stainless steel version
Silencers, Mounting feet, Vibration isolators, Matching flanges, Flexible connectors, Air operated non return dampers, Guards, Bell mouth inlets. Electronic and transformer type speed controllers and frequency inverters.
The fans are tested to the latest internationally recognised standard IS05801 Part 1 (1997), installation category D (AMCA approved) for aerodynamic performance and BS848 Part 2 (1985) for acoustic performance
35JM/16/4/5/34 - 400V - S-casing + MFS + AVM + MFL + FLX
35JM= fan
16= hub diameter
4= 1420rpm - 2= 2910rpm - 6=900rpm
5= number of blades
34= pitch angle
400V= supply 3ph - 230V= supply 1ph
MFS= mounting feet set
AVM= anti-vibration mount set
MFL= matching flange
FLX= flexible connector
